First some terminology…
Sailboats have barriers along the perimeter of their decks that are meant to keep people from falling off. We call these barriers lifelines. Lifelines have gates that can be opened to let people walk through them when docked or rafted up. These gates are typically created by putting a piece of hardware that opens and closes on the lifeline at the gate called a pelican hook.
Still with me?
Pelican hooks have a tiny little ring that you pull to open them. It’s usually difficult to grab the little ring just right.
To make it easier, you can put a little fob, or lanyard, on the ring that you can more easily grab and pull the pelican hook to open the gate in the lifeline.
Long story short, today I made a set of these lanyards for Nirvana’s lifeline gates. 2 for port, 2 for starboard.
Here’s how I made them if you’re interested.
The easy part is learning how to tie the individual cobra weave knots. So I’ll leave that out and just share one of many links that I looked at to help me figure out the basic cobra knot: here. The hard part was figuring out the best jig or setup to easily secure the cord while tying the cobra knots. I’ll share what I came up with.
What you’ll need:
– 95 paracord (1.75mm wide)
– measuring tape
– lighter or hot-knife to melt cut ends of the cord
– carabiner with 2 big paper clips attached (the jig I came up with)
– tweezers and/or a crochet hook to pull the working ends of the cord back through and under the cobra weave knots to bury them and finish the lanyard
To make a 3-1/2″ finished lanyard out of 95 paracord, I used 44″ pieces for each lanyard. Cut to length and fold that in half.
Tie a simple overhand loop knot 3 1/2 inches from the midpoint of the piece of cord. This defines the finished length of the lanyard.
The carabiner and paper clips make up my jig for holding the cord while tying the cobra weave knots. Other people use different things; pegboards, wire harnesses, etc. Basically, you want something you can pull against to keep the cord taut while you are tying the cobra weave knots with the two working ends of the cord. This is what worked for me.
The carabiner can easily be clipped onto a drawer handle or hook. The paper clips make it easy to loop the 2 working ends of the cord to start the first cobra weave knot. And they make it easy to slip the finished lanyard off them as well.
Before tying the first cobra weave knot…
After tying 3 to 4 cobra knots…
Keep tying cobra weave knots (9 or 10) until you have about 1 inch of the loop left. Remove lanyard from carabiner and paper clips.
To finish the lanyard, you need to pull the working ends of the cord back under the length of cobra weave knots that you just tied. This will bury them and keep the lanyard from coming untied when it is in use. This is where the tweezers and/or crochet hook come in. I pulled the working ends under about 4 or 5 of the knots.
Then trim and melt the cut ends of the cords; the finished lanyard…